Tube Microphone Grille

This grille has 3-layer mesh. It is finished in a satin nickel plating.

It fits the following tube microphones:

• Apex 460
• Alctron T11-A
• Avantone CV-12 (but note that these grilles do not have switch markings)
• BadAax T11-A
• Carvin CTM-100
• Stellar CM-5
• MicParts V-12 and V-47
• MicParts 12-251 tube mic kit
• MicParts V-251 tube mic and DIY kit

 It also fits these small FET condensers:

• Apex 435
• t.bone SC400
• CAD GXL2400 (but NOT the GXL2200)
• MicParts S-25 and T-25
• Most BM700 and BM800 (cheap Ebay mics; see photo)

This grille is tapped and threaded for M2 Metric machine screws. If your donor mic uses smaller screws (e.g. M1.6 Metric), then you will need to source or supply two M2 screws to install this grille.

Click for other Apex 460 mods.

About "Imperfect" Grilles

We occasionally have a few "Imperfect" grilles listed here. These grilles failed our quality standards; they are either tilted, or have finish problems in the mesh and/or grille. They are fully functional, but suffer from minor cosmetic defects. We sell them below our cost; all sales of blemished/imperfect grilles are final.